Bay windows add character and space to a home 24200

Bay Windows Add Character And Area To A Home

It was the perfect area. Our California ranch design home had a big photo window in the front room. The window extended from a few inches above the flooring to only a few inches below the cathedral ceiling. The walls and ceiling were redwood stained knotty pine and the flooring was a coordinating hardwood. The window kept an eye out over a flower bed, shrubs and the expanse of front yard. It was the ideal window to be replaced with a bay window.

The window was nearly square. It was 72 X 72 inches. We thought about a bow window, but elected to set up a bay window instead. We just felt that our particular home looked much better with three panel bay window rather than the numerous panel bow windows. Our intent was to fill the seat board of the bay with potted plants we had being in front of the present image window. The brand-new arrangement would give us a bit more area in the room and improve the total appearance of your house. It was time best rated plumber Cranbourne to go shopping.

Scratch vs. Pre-built

When we first got the idea of installing the brand-new window, I started collecting prepare for developing a bay window. Thumbing through books and publications, and the Web online search engine, I discovered a number of prepare for developing a bay window from scratch. I also discovered that undertaking such a task was going to be unnecessary. The majority of the significant window makers, such as Pella, Milgard and Anderson make both completely pre-assembled bay windows along with pre-built components for bay windows.

These days extremely few contractors will handle the task of constructing a bay or bow window from scratch. It just isn't useful when for the same or less money they can set up a high quality pre-built window. If the specialists use pre-built windows or components for brand-new house building or renovation jobs, then we could do the same for our remodeling job, we reasoned.

Installing a bay window can quickly be a do-it-yourselfer task. Before you go the diy route, however, you may wish to line up a specialist to help out if required. This is not going to be a job that you can finish throughout a Saturday afternoon. Possibilities are you are not going to finish it in a weekend, for that matter.

You are also going to want to line up some help. Bay windows and window parts are heavy. A minimum of they are too heavy for one person to handle.

Be sure and check out the weather report, including the long range projection. Setting up the window implies opening a hole into your home. It can take a couple of days to get the new window in place and sealed. The last thing you want is for rain to come gathering on your floor, walls or furniture.

Be sure and check your Baxter plumbing repairs city or neighborhood building and construction codes. There may be special regional requirements, such as having safety glass in low profile windows. You are probably going to require a building permit anyway, so that is also a great time to examine the codes.

Tools and Materials Needed

The tools you will require for this project include a tape measure, a framing square that you can also utilize as a straight edge, a circular saw or miter saw, crow bars, drill and bits, level, stapler, utility knife, tin snips and a caulking gun.

The products you will require include the bay window system, the support brackets, nails, roof paper, shingles, roof nails, outside grade silicone caulking and fiberglass insulation. You will also need 1X6 inch boards for the window skirting. If you are expanding an existing window, or if you are setting up the window in a space that was previously the wall, you will also require 2X4s for cripple studs and additional framing.

Basic Installation Steps

1. Develop window position in the wall. Eliminate the existing window. Determining the bay window, mark on the outside of your house the opening needed for the brand-new window. Using your circular saw, cut the required opening.

2. Framing. Build the framing for the new window. This will likely consist of cutting through existing studs and putting in a new header, rough sill, jack studs and cripple studs.

3. Install the support braces. A window approximately five feet wide will take a minimum of 2 assistance braces. A larger window will need 3.

4. Set the window in place. Lift the bay window on the assistance braces and slide it into the rough opening. Shim as essential to level the window. Anchor in place.

5. Develop the window roofing system. Set the roof frame on top of the bay window system and nail in location. Fill the area in between the roofing system best plumber Dandenong and the top of the bay window with insulation. Attach the roof sheeting to the frame and cover with roofing paper. Set up the drip edges and the flashing and after that shingle.

6. Set up the window skirting around the bottom of the window. Fill will insulation and then attach the skirt bottom to seal the beneath side of the window.

7. Seal the edges with silicone caulking.

This is a list of the standard installation actions and they have been abbreviated in the interests of simpleness and area. The window unit you buy will have total installation steps. Take it from the voice of experience; it truly makes the project go much more efficiently and it will be finished in much less time when you check out and follow them.

In our case, I had two good friends helping with the task. We have actually collaborated on other projects and work together well. We had the old window out and the rough framing completed on Saturday afternoon. We buttoned up the hole with plywood over night and returned to work the next day. By affordable plumber in Dandenong Sunday night we had the new window installed and the roofing and skirting completed. On Monday afternoon I finished sealing up the outside and completed the trim work for the within.

And, we were right. It was the perfect spot for a bay window. It looked fantastic from the outside. Inside, it ended up being the focal point of the space and added a special charm to your house. The window provided your house included character and value.

When it came time to offer your home, it was one of the features that were especially appealing to the purchasers.